![]() Cyan flashes three times: WiFi turned on.After 15 minutes, WiFi automatically turns off to conserve power. Blue flashes continuously every 5 seconds: Represents that WiFi is on and the user is able to connect to the Blink Wireless Access Point (AP).Green flashes three times: Blink has been connected to a power source (only for firmware v2.02 or newer).Below is a list of each LED flash type and what they represent. LED Status Indicatorīlink is equipped with an RGB LED which provides the user with a full range of feedback. *Do not connect anything other than the motion detector cable into this input!* 4. Port 2 (3.5mm stereo audio): This port is used for Motion Detector Schedules and can be used with our X-Band Motion Detector accessory, or another 5V trigger signal such as a PIR sensor. (See section Motion Detection for more information). The Wired Remote is used to turn Blink's WiFi On/Off, as well as provide LED feedback during operation.Ĥ. Port 1 (2.5mm stereo audio): This port accepts the Wired Remote or other custom trigger. See section LED Status Indicator for an explanation of the different LED indicators.ģ. LED: This provides feedback to the user during operation, as well as for firmware updates. Powering Blink for available power configurations.Ģ. miniUSB: Blink's USB interface is used for firmware updates (See section Updating Blink for more information). X-Band Motion Detector (optional purchase)ġ. You can also view helpful instructional videos in the “ Support” section. Read our Quick Start Guide to get started and this more detailed User Manual for further details. Configuration is handled through an easy-to-use web interface via a smartphone, tablet or laptop. Blink allows users to control when and how the camera will trigger based on a daily schedule, motion detection, or other custom made triggers. Blink is a low power, WiFi enabled GoPro time lapse and scheduler accessory that unlocks the full potential of the GoPro camera. ![]() This manual describes how to get started with your CamDo Blink Time Lapse Controller for your GoPro HERO4 or HERO3+ Black camera (NOTE: HERO3+ Silver cameras may work but are not officially supported by CamDo due to the general unreliability of the HERO3+ Silver cameras as they get older).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |